Serpent 402195 Antiroll bar 1.3 X26 anti-roll bar for Medius X26 steel EP  [SER402195]

Antiroll bar for Medius X26

This Serpent 402195 is an RC-scale anti-roll bar intended for fine-tuning chassis roll behaviour on compatible 1/10 electric touring car platforms. The 1.3 designation identifies the bar thickness within the part name and indicates its role as a medium-stiffness option compared with thinner or thicker bars.

Compatibility is limited to the Medius X26 steel EP chassis family as referenced by the Serpent Medius X26 steel EP (SER400052) parts grouping; do not assume fitment on other models without verifying mounting points. The part is an aftermarket spare intended to replace the existing anti-roll bar on the same mounting layout.

Installation is mechanical and performed at the suspension linkage and end-mount locations used by the original bar. Expect to reuse the chassis' existing linkage hardware and mounting brackets when fitting this bar, and verify free movement through full suspension travel after installation to prevent binding.

Tuning notes: swapping to a 1.3 section changes lateral roll stiffness and the balance between front and rear roll rates. Use this bar when incremental changes to understeer/oversteer balance are required, and make one change at a time so effects are measurable during setup sessions.