Serpent 402196 Antiroll bar 1.4 X26 for Medius X26 steel EP (SER400052)  [SER402196]

Antiroll Bar 1.4mm for Medius X26

The Serpent 402196 antiroll bar is an RC-scale suspension component intended for use with the Medius X26 steel EP platform (SER400052). As a 1.4mm option, it provides a straightforward way to influence lateral stiffness and body roll without altering shock or spring rates.

Installation is a chassis-level operation: the antiroll bar mounts to the suspension linkage points specified by the Medius X26 layout. Ensure linkages are free to pivot and that end links align without binding during full suspension travel. Correct fit preserves predictable roll behaviour and keeps suspension geometry consistent.

In tuning terms, moving to a 1.4mm antiroll bar will tend to increase roll resistance compared with thinner bars, concentrating changes to transient roll and corner entry balance. Use it as part of a stepwise setup process, adjusting one element at a time and testing on-track to observe handling changes.

Maintenance is minimal for steel bars: inspect for play in link connections and for surface wear after heavy use, re-tighten mounting hardware to manufacturer torque guidance, and replace if deformation or excessive wear is present.

Use the Serpent 402196 antiroll bar to fine-tune roll behaviour on Medius X26 steel EP cars, integrating it with incremental suspension adjustments for predictable on-track results.