Serpent 601353 Shockmount Aluminium hardcoated RR for SRX8 Gen4 GP (SER600024)  [SER601353]

Hardcoated aluminium shockmount (RR)

This is an RC-scale aluminium shockmount supplied under the Serpent model number 601353, listed as the hardcoated RR unit for use with SRX8 Gen4 GP (SER600024) parts. The component is intended as a direct replacement mount focusing on wear resistance and repeatable mounting geometry rather than cosmetic change.

As a structural suspension mounting part, the hardcoated aluminium surface reduces abrasion where the shock assembly meets the chassis and helps maintain consistent alignment under load. In practical setup work the mount’s stiffness and surface finish affect how the shock top and lower mounting points behave during compression and rebound cycles, so consider the mount as part of the overall suspension tuning package.

Installation is typically a straightforward swap at the rear-right (RR) shock location when replacing a like-for-like part on a compatible SRX8 Gen4 GP chassis, however check the seller listing for included fasteners and confirm thread inserts before reassembly to avoid cross-threading or over-torque on aluminium components.