Serpent 601357 Shock Spacer for SRX8 Gen4 GP Chassis  [SER601357]

Shock spacer role and fitment

This Serpent 601357 shock spacer is an RC-scale accessory intended for use with the SRX8 Gen4 GP chassis family. It functions as a simple suspension tuning item that alters shock stack height or preload position to influence ride height and shock travel characteristics without changing spring rates or damper internals.

The spacer provides a discrete way to fine‑tune handling: moving the spacer between shock components changes leverage and effective ride height, which can help balance front-to-rear weight transfer and adjust turn-in behaviour on different track surfaces. Keep in mind this description refers to RC model setup only.

Installation guidance (general):

• Verify the spacer aligns with the shock shaft and upper/lower shock mounts on the SRX8 Gen4 GP before final assembly.
• Reassemble the shock with the spacer in the desired position, then check static ride height and full travel to confirm no binding occurs.
• After initial fit, perform short test runs and adjust spacer placement incrementally to observe handling changes rather than making large jumps.

Tuning notes:

• Small spacer increments produce subtle handling changes—use them for fine balancing rather than major setup shifts.
• Combine spacer adjustments with spring and damper tuning for targeted results, keeping track of each change so you can revert if needed.