Serpent 601367 Throttle lever Aluminium 25T SRX8 Gen4  [SER601367]

Throttle lever for SRX8 Gen4

This is an RC-scale throttle lever engineered for the SRX8 Gen4 platform, supplied under the Serpent reference 601367. Machined aluminium with a 25T profile provides a direct replacement for factory lever parts on SRX8 Gen4 kits, and is intended for use in RC GP setups where stable throttle geometry matters.

Installation is straightforward for hobbyists familiar with throttle linkages, the lever mounts to the existing throttle shaft and uses the vehicle's original fastening hardware. Check alignment and throw during setup, make incremental adjustments to avoid binding, and verify full throttle and idle positions before track use.

In tuning the SRX8 Gen4 throttle response, this aluminium lever helps reduce flex compared with common plastic levers, allowing crisper input transfer from the servo to the carburettor linkage on GP-style RC cars. Use it as part of iterative adjustments to lever length and servo arm selection to refine pedal feel and throttle resolution.

Neutral component choice for chassis maintenance and tuning, intended to integrate with SRX8 Gen4 throttle systems on RC GP kits.