Serpent 601380 Servo lever throttle, replacement throttle lever for SRX8 Gen4 GP (SER600024)  [SER601380]

Throttle servo lever for SRX8

This Serpent 601380 servo lever throttle is an OEM replacement-style servo arm intended for use on Serpent SRX8 Gen4 GP (SER600024) car kits. It serves as the mechanical link between the steering servo output spline and the throttle linkage, providing a direct mounting point for setting servo throw and throttle travel.

Installation is straightforward for hobbyists familiar with basic servo work: remove the original servo lever, align the replacement lever on the servo spline at the desired neutral position, secure with the existing retaining screw, then connect and check the throttle linkage for free movement through the stroke. Always verify center and end-point settings on your transmitter before full testing.

In setup and tuning the lever has a simple role: it defines leverage and geometry for the throttle linkage, so small changes to lever position and servo arm length affect sensitivity and available travel. Use incremental adjustments to match servo torque and desired throttle response, and confirm there is no binding at full travel.