Serpent 601384 Suspension bracket rear SRX8 V2  [SER601384]

Price:
USD$27.10
Brand:
Serpent
Model:
SER601384
Condition:
Brand New
Write a review

Rear suspension bracket for SRX8 V2

This Serpent 601384 suspension bracket is an RC-scale replacement part intended to mount and position rear suspension linkages on SRX8 V2 platforms. It focuses on providing a stable mounting point to influence rear roll center and toe behavior without changing other hub components.

Compatibility is limited to the chassis codes listed in the specifications below, use this bracket when you need a direct swap for a damaged or worn rear bracket or when adjusting rear geometry during setup sessions. The description remains technical and practical for hobbyists servicing 1/8 scale on-road cars.

Specifications

  • Item: Suspension bracket rear RR RR
  • Material: Aluminium
  • Model Number: Serpent 601384
  • Compatibility: SRX8 V2, SRX8 Gen4 GP (SER600024)

Keep original fasteners and check alignment after installation, adjust rear geometry incrementally and test on-track to confirm handling changes.

Is this bracket a direct fit for SRX8 V2?

The bracket is listed for SRX8 V2 compatibility, verify part orientation and hardware with your chassis before final assembly.

What material is the bracket made from?

The specification lists aluminium as the material, suitable for standard on-track use and routine setup adjustments.

Do I need different screws to install it?

Use the original mounting hardware where possible, replace any stripped fasteners with the correct size hex screws from your parts kit.

How does this bracket affect handling?

Changing the bracket can alter rear mounting geometry which affects roll center and toe response, so tune incrementally and test on-track.

Copyright © 2008-2026 rcjaz.com All rights reserved