Serpent 601385 Suspension bracket front/rear for SRX8 V2  [SER601385]

SRX8 V2 suspension bracket overview

This RC-scale suspension bracket is listed as Serpent model SER601385 and serves as a direct replacement or spare for front and rear mounting positions on SRX8-series race cars. Its role is structural and tuning-focused, providing the mounting point that affects suspension geometry, alignment repeatability, and component wear patterns during club and competition use.

The bracket is offered to match SRX8 V2 layouts while also aligning with parts used in SRX8 Gen4 GP configurations where applicable. As a chassis-level component it interfaces with uprights, lower arms, and shock tower connections; attention to fitment and symmetry is key when swapping brackets to preserve handling balance.

During setup and tune cycles, this bracket influences roll centre and camber behaviour under load. Technically-minded hobbyists use replacement brackets like this to correct minor chassis damage, trial alternate geometry, or ensure reliable mounting after prolonged use. Inspect threaded inserts and bore fits after installation to avoid binding that can alter suspension response.

Compatibility

• SRX8 V2
• SRX8 Gen4 GP (SER600024)

For RC racers and builders maintaining SRX8 platforms, SER601385 provides a direct replacement bracket option to restore mounting integrity and retain intended suspension geometry, helping keep setup changes predictable between practice and race sessions.