Serpent 601401 Steeringblock pin set KPI V2 SRX8  [SER601401]

Steeringblock pins for SRX8 KPI V2

This Serpent 601401 steeringblock pin set is an RC-scale replacement and tuning accessory designed for the SRX8 platform, following the KPI V2 steering geometry. The set is supplied as a (2+2) pcs configuration to match left and right mounting points, intended for routine maintenance or when swapping steering components during a setup change.

In practice this pin set serves as the retention and pivot point for the steeringblocks, helping maintain consistent front-end geometry after servicing or after track impacts. It is neutral in design and focused on preserving the intended KPI V2 alignment rather than altering geometry radically.

Installation is straightforward for anyone familiar with SRX8 maintenance: remove the steeringblock assembly, replace the worn pins with the new set, confirm there is no unwanted play, and verify steering travel and toe settings during final assembly. Regular inspection of these pins is recommended as part of front-end service intervals to ensure predictable handling.