Serpent 601402 Carbon wishbone rr  [SER601402]

Carbon rear wishbone for SRX8GTR chassis

The Serpent 601402 carbon wishbone rr is an RC-scale rear suspension arm designed to interface with SRX8GTR EC GP SER600077 platforms. Built from carbon material, the component focuses on providing a stiff, lightweight replacement that preserves factory geometry while allowing precise tuning of rear-end response.

Fitment and installation are straightforward when matched to the stated chassis code; verify alignment with existing mount points and use the original hardware where possible. Avoid over-torquing attachment screws and check clearances for the drive components during initial installation. If the part replaces a damaged plastic arm, verify ball stud and hinge pin fit before track use.

In setup terms, the rear wishbone influences toe, roll center behavior and lateral stiffness of the rear end. Small changes in arm length or mounting position can shift handling balance, so use incremental adjustments on the shock and toe settings to validate the effects. Regular inspection for surface cracks or delamination is recommended after heavy impacts.

This carbon wishbone is intended as a direct aftermarket replacement for the specified Serpent chassis, serving suspension tuning and durability goals without altering core chassis layout.