Serpent 601405 carbon outside rear wishbone mount for SRX8GTR EC GP  [SER601405]

Outside rear wishbone mount

This is a carbon outside rear wishbone mount designed as an RC-scale replacement part for the Serpent SRX8GTR EC GP platform. The component is intended to mount on the outside of the rear suspension wishbone and acts as a structural interface between the chassis and the lower suspension arm, helping to locate the arm and transfer loads during driving and setup changes.

The part is manufactured from carbon fiber to provide a high stiffness-to-weight ratio while keeping mass low on the rear end. As an aftermarket spare for the SRX8GTR EC GP (SER600077) family, it preserves the original mount geometry and mounting points so it fits the specified chassis without requiring modification.

Installation is straightforward when replacing the existing outside mount: align the mount to the standard rear wishbone mounting points and secure using the chassis hardware already in place. Because this is an RC-scale accessory, it is intended exclusively for model use and does not have any road vehicle application.

In tuning terms the outside mount affects rear roll center and lateral compliance; swapping to a stiffer carbon mount can reduce flex and give a crisper rear response, while a more compliant mount increases mechanical grip in low traction conditions. Evaluate changes incrementally when adjusting handling characteristics.

Use this carbon outside rear wishbone mount to maintain correct geometry on SRX8GTR based setups and to explore rear-end stiffness changes as part of suspension tuning for track or club racing.