Serpent 601407 Carbon wishbone bushing inside fr/rr  [SER601407]

Internal carbon wishbone bushing

This Serpent 601407 carbon wishbone bushing is an RC-scale internal bushing designed for the front and rear wishbones, intended to locate and guide the wishbone inner pivot without altering outer linkage geometry. The carbon construction provides a lightweight, low-deflection contact surface for the wishbone pin and helps maintain consistent suspension alignment under load.

Fitment: use this part where the original kit specifies an internal wishbone bushing; listed compatibility includes SRX8GTR EC GP (SER600077). Confirm the part number matches your chassis before installation.

Installation and maintenance notes: press or fit the bushing into the wishbone bore until fully seated, check for smooth rotation on the wishbone pin, and inspect for abrasion after initial runs. Replace worn bushings to prevent slop at the inner pivot and to keep toe and camber consistent.

Tuning role: this bushing affects pivot smoothness and repeatability rather than spring rate; stiffer, lower-compliance bushings like carbon can sharpen steering response and improve predictability during cornering, while more compliant inserts will allow minor self-centering and more forgiveness on rough surfaces.