Serpent 601409 carbon wishbone bushing outside rear for SRX8GTR EC GP carbon part  [SER601409]

This is an RC-scale carbon outer wishbone bushing designed for the rear outside position on Serpent SRX8GTR EC GP (SER600077) layouts, sold as a single replacement piece for maintenance or tuning. The component is intended to interface with standard wishbone mounts and inner pivot hardware to influence rear suspension geometry.

Use this bushing when restoring worn plastic bushings, increasing chassis stiffness at the arm pivot, or when experimenting with tighter rear toe and camber response. Installation typically requires removal of the rear lower arm, inspection of mating surfaces, and reassembly with the original pins and retaining hardware. Check fit and clearances before finalising setup.

When tuning, expect subtle changes to suspension feel rather than radical handling shifts; this part plays a precise role in reducing flex at the outer pivot and can assist in achieving more consistent suspension behavior across runs. Always verify compatibility with your SRX8GTR EC GP (SER600077) assembly and secure fasteners to manufacturer torque guidelines.