Serpent 601413 Carbon front wishbone set for SRX8GT  [SER601413]

Carbon front wishbone for SRX8GT

This Serpent SER601413 front wishbone set is a carbon fibre replacement intended for the SRX8GT chassis, supplied as a ready-to-fit part for the front suspension assembly. The text focuses on fitment, material behaviour, and how the component is used in tuning suspension geometry rather than dimension specifics.

In practical use the part replaces the factory front A‑arm to restore or alter suspension geometry; installers should check ball bearing seats and hinge-pin fit before final assembly. Because the component is carbon fibre, expect high stiffness compared with standard composite arms, so small setup changes at the shock or steering link can produce noticeable handling differences.

Installation notes: verify hinge-pin alignment and use the correct hex screws for clamping points, confirm clearance to steering linkages and servo horn travel, and retorque fasteners after the first running session. Regular inspection for delamination or edge chipping is recommended as part of routine maintenance.

Compatibility

Designed for use on the SRX8GT chassis as specified by the product title, intended to replace the original front wishbones without modifying chassis components.

Use this set when repairing or adjusting front suspension geometry on SRX8GT projects, and pair with routine checks of hinge pins, shock mounting and steering link clearances for reliable results.