Serpent 601414 Carbon wishbone set rr SRX8GT  [SER601414]

Carbon rear wishbone for SRX8GT

This Serpent 601414 carbon wishbone set rr is an RC-scale replacement for the rear wishbone positions on SRX8GT platforms. The set uses carbon fiber to increase lateral stiffness compared with typical molded parts, helping keep suspension geometry more consistent under load while remaining lightweight.

Fitment and installation are straightforward when used with the stock SRX8GT rear suspension mounting points and standard fasteners. The parts are intended as direct-replacement components for hobbyists focused on chassis balance, roll response, and predictable rear-end behavior during cornering and acceleration in electric and nitro RC setups.

Tuning role: use these wishbones to reduce unwanted deflection at the rear, refine toe and camber consistency through the travel range, and support finer adjustments to shock and roll-center settings without altering other suspension components.

For builders adjusting rear-end stiffness and precision on SRX8GT-series chassis, these Serpent carbon rear wishbones provide a direct, material-focused upgrade that supports consistent suspension geometry without changing mounting hardware.