Serpent Medius X26 Bulkhead Brace Graphite by Factory Pro O-SPP004  [FP-O-SPP004]

This graphite bulkhead brace is produced by Factory Pro for the Serpent Medius X26 platform and is intended as an aftermarket reinforcement part for RC touring cars. It is a scale accessory designed to mount to the Medius X26 bulkhead area to influence chassis behaviour during cornering and transitions.

Functionally the brace adds localized stiffness at the bulkhead junction. That change alters flex characteristics so drivers can fine‑tune balance between front and rear grip without changing suspension geometry. Use it as part of incremental setup adjustments when tuning for consistent lap times or improving mid‑corner stability.

Installation is straightforward for hobbyists familiar with typical Medius X26 disassembly: remove the body where needed, unbolt the existing bulkhead fasteners, place the graphite brace in position and secure using the original hex screws. Recheck clearances for driveshafts and linkages after tightening.

Compatibility is limited to the Serpent Medius X26 chassis only, check your chassis code before ordering to avoid mismatches. This is an RC-scale component and not intended for any full‑size vehicle use.