Serpent Medius X26 Lower Suspension Arm Set Graphite by Factory Pro O-SPP007  [FP-O-SPP007]

Lower suspension arm for Medius X26

This Factory Pro replacement is an RC-scale lower suspension arm set intended for use on the Serpent Medius X26 chassis, supplied as one set per car. The parts are produced in graphite to offer a balance of stiffness and damping response appropriate for fine suspension tuning on 1/10 on-road models.

The arms act as direct-fit replacements for the factory items on Medius X26 layouts, and are intended to influence roll center and lateral stiffness when paired with your existing uprights, hinge pins, and hardware. Installation requires basic RC tools and a routine check of hinge-pin alignment, camber link geometry, and free travel to avoid binding.

For setup, use the graphite arms to explore changes in mid-corner grip and transient response; monitor wear at pivot points and replace or service hinge pins and bushings as needed. Always confirm clearance with steering and suspension travel before full-power runs.

These graphite lower arms are suitable for hobbyists who want to tune Medius X26 suspension behavior; follow standard RC maintenance and check fitment before use.