Serpent Medius X26 Main Chassis Graphite 2.25 by Factory Pro O-SPP001  [FP-O-SPP001]

Main chassis for Serpent Medius X26

This Factory Pro produced main chassis is designed for the Serpent Medius X26 1/10-scale touring platform and is specified as a graphite 2.25 main plate. It is intended as an aftermarket replacement part to adjust chassis stiffness and influence handling balance for track and practice use within the RC scale context.

Fitment focuses on direct replacement of the factory main plate on Medius X26 layouts. When planning a swap, verify existing components align with the Medius X26 mounting pattern and that standoffs and electronics clearances match the graphite plate profile. The material choice and thickness aim to alter flex characteristics so pilots can tune understeer/oversteer tendencies without modifying suspension geometry.

Routine checks after installation include fastener torque, visual inspection for delamination or edge wear, and confirming no interference with servo, ESC, or motor placement. Graphite surfaces are lightweight and rigid compared with composite plates, so small setup changes in spring rates or anti-roll bars may be needed to restore the desired handling balance.

Compatibility

• Serpent Medius X26

Use this chassis plate when you need a straightforward method to change overall chassis rigidity on a Medius X26, and pair it with controlled suspension adjustments to evaluate its effect on lap consistency.