Serpent Medius X26 Rear Body Plate Graphite by Factory Pro O-SPP010  [FP-O-SPP010]

Rear body plate for Medius X26

This replacement rear body plate is an RC-scale hop-up produced by Factory Pro specifically for the Serpent Medius X26 chassis. The part is identified by Factory Pro O-SPP010 and is supplied in a graphite finish intended to match the vehicle's rear body mounting points.

Functionally the plate serves as a direct-replacement body mount panel and as a minor tuning item where stiffness and weight distribution at the rear can influence handling. It is intended for hobby use on the Medius X26 chassis only, and should be fitted using the original mounting locations and hardware from the car.

Installation is straightforward on the Medius X26 platform: remove the damaged plate, check the alignment of mounting posts and holes, transfer original screws or hardware, and confirm body clearance around the suspension and motor area. After installation, verify that the body sits true and that there is no interference with the suspension travel or rear gearbox components.

Maintenance advice: inspect the graphite plate for cracks after impacts, keep mounting faces clean, and retorque fasteners after the first run to ensure correct seating. Use this part as a service replacement or to restore original body geometry after a crash.