1/10 Buggy rear-right rim
This Serpent SER214015 rim is an RC-scale 1/10 buggy rear-right wheel intended for use on 1/10 off-road buggies. The listing identifies the part as a rear-right replacement rim in white, offering a direct-format fit where the model designation matches your vehicle's wheel mounting style.
Focus in this write-up is mechanical fit, installation considerations, and how the rim affects on-track setup. As an accessory for scale buggies, the rim's primary influence is wheel offset and tyre seating; those factors directly affect rear track width, tyre alignment, and how the car transfers power and cornering loads through the rear axle.
Installation notes: verify hub hex size and wheel nut/washer stack before fitting, mount the tyre evenly on the bead to avoid imbalance, and check for correct directional fit when a part is marked rr (rear-right). Use proper wheel hardware torque and confirm clearance to suspension and body to prevent rubbing during full suspension travel.
Tuning role: when adjusting rear bite, engineers and hobbyists swap rims and tyre combinations to change scrub radius and track width. A change in rim offset can shift the tyre contact patch laterally, which affects how the rear end steps out under power and during corner exit. Use rim changes alongside tyre compound, ride height, and shock tuning to dial in predictable rear behaviour.
Maintenance tips: inspect the bead area after each running session for cuts or deformation, clean tyre beads and rim mating surfaces before glueing or mounting, and rebalance wheels if you notice high-speed vibration that could be rim- or tyre-related.
