Serpent SER500888 13mm front shock body replacement part  [SER500888]

13mm front shock body for Serpent

This is an RC-scale front shock body intended as a replacement or service part for Serpent shock assemblies that use a 13mm diameter shock tube. The component addresses the mechanical housing of the front damper and plays a direct role in oil volume, piston travel and sealing performance within typical 1/10 scale touring and on-road setups.

Practical notes for installation and setup:

• Verify that your shock uses a 13mm outer diameter body before ordering to ensure fit with Serpent shock caps and shafts.
• When removing the old body, drain oil and inspect pistons, shafts and seals for wear so they can be serviced or replaced as needed.
• Use compatible shock oil and maintain correct oil level and bleed to achieve the intended damping characteristics; small changes in oil height alter low-speed and high-speed damping.
• Check O-rings and thread engagement during reassembly to prevent leakage and preserve consistent rebound.

The part is strictly for RC model use and should be handled as a model-scale shock component during maintenance and tuning.

A straightforward replacement for Serpent 13mm front shock applications, intended to restore or adjust front damping behavior on hobby-grade 1/10 scale cars.