This Serpent SER601383 suspension bracket is an RC-scale replacement part intended for use on Serpent SRX8 V2 platforms. It serves as a dedicated rear/front mounting bracket within the car's suspension assembly, providing a direct swap for worn or damaged pieces during routine maintenance or setup changes.
The description focuses on compatibility and function rather than cosmetic detail: the bracket locates suspension links and shock positions, affecting roll centre and geometry when adjusted. Technically, this part is used where the rear and front suspension mount points converge with the chassis, so understanding its role helps with predictable tuning outcomes.
Installation notes: remove only the affected mounting hardware, compare the old bracket to the SER601383 for pin and screw alignment, and reassemble using the original fasteners. Check suspension travel and wheel alignment after fitting and perform a short test run to confirm expected behaviour before finalising setup.
Use this bracket when you need an exact-fit replacement that preserves SRX8 suspension geometry, and verify fitment and alignment during reassembly to maintain chassis balance and handling consistency.
Copyright © 2008-2026 rcjaz.com All rights reserved
