Tamiya 15550 Jr HG Carbon Brake Stay (1.5mm) - 1/32 Mini 4WD Jr. HG carbon brake stay for front/rear/side stay use  [15550]

Tamiya 15550 Jr HG Carbon Brake Stay (1.5mm) - carbon brake stay for Mini 4WD

Tamiya 15550 Jr HG Carbon Brake Stay (1.5mm) is a carbon spare part intended as a replacement front/rear/side brake stay for 1/32 Mini 4WD models and is catalogued as an accessory in the Mini 4WD range.

This component is a 1.5mm-thick carbon plate cut for use as a brake stay. It is supplied as a raw carbon stay intended for builders who replace or stock spare mounting plates; no additional hardware or conversion parts are included with the plate.

Material and form: the stay is a carbon plate with 1.5mm nominal thickness. As a spare part it is intended for use where standard stay mounting patterns exist; confirm hole spacing and screw size against your existing stay before installation.

Compatibility and installation notes

• Intended for 1/32 Mini 4WD use as a front, rear or side brake stay plate.
• Verify that hole alignment matches your car's stay mounts; minor re-drilling may be required for non-standard setups.
• Use appropriate screws and washers to prevent carbon edge cracking; avoid over-tightening.
• Not a body or chassis replacement kit; sold as a single carbon stay plate only.
• Not intended for Wild Mini 4WD or Scale Mini 4WD series upgrades.