Tamiya 74168 - MINI 4WD 2mm Screw Cutter, side cutter for Mini 4WD maintenance  [74168]

Mini 4WD 2mm Screw Cutter

This Tamiya 74168 MINI 4WD 2mm Screw Cutter is an RC-scale hand tool designed for tidy trimming of 2mm screws and cap screws used on Mini 4WD cars. It pairs a precision stainless steel cutting edge with a riveted pivot and a compact elastomer grip to give a controlled cutting action tailored to model work rather than general-purpose hardware use.

To use, insert the screw from the tool's front opening so the cutting edge meets the shaft where you want the cut, then squeeze the grips in a steady motion. The cutter is intended to produce a flat, clean finish that reduces the need for filing compared with results from pliers or generic wire cutters, helping keep body panels, wheel hubs, and other chassis areas free of protruding fastener ends.

The tool's role in setup and tuning is straightforward: trim excess thread on set screws and cap screws after installation to avoid interference with clearances and to improve the appearance of trim work. Keep the cutter dedicated to screws and similar soft fasteners common to Mini 4WD assemblies to preserve blade life.