Tamiya 95716 Jr HG Carbon Rear Roll Stay - Super X Chassis 1.5mm rear roll stay  [95716]

Tamiya 95716 Jr HG Carbon Rear Roll Stay for Super X chassis

The Tamiya 95716 Jr HG Carbon Rear Roll Stay is a 1.5mm carbon fiber rear roll stay intended as a replacement or service part for Mini 4WD models using the Super X chassis. It sits in the spare-parts category and is specified to interface with Super X mounting patterns.

Constructed from a thin 1.5mm carbon sheet, this rear roll stay is intended to add a rigid mounting point for rear rollers while keeping package height low. The part is presented for hobbyists who need a direct-fit carbon stay for Jr HG‑sized components on Super X builds, focusing on material and fit rather than cosmetic detail.

Installation requires standard Super X chassis rear stay mounting hardware and care when tightening fasteners to avoid crushing the carbon laminate. Experienced builders will note that 1.5mm carbon balances stiffness with modest flex; consider using appropriate shims and washers to control plate-to-screw contact and to protect the hole edges from wear.

When assessing replacement parts, inspect the mounting holes for delamination and confirm roller alignment with existing rear bumper and bumper plates. Carbon edges can be finished lightly to remove splinters; do not alter hole positions unless you intend to ream and reinforce the area for different screw sizes.

This part is a straightforward carbon rear roll stay for Super X chassis applications; use it as a direct spare or to replace worn plastic stays where the Super X mounting pattern is retained.