TAMIYA CC01 Rear Bevel Differential Gear 7pcs set by GPM SCC1200R  [SCC1200R]

Rear bevel differential for CC01

This aftermarket seven-piece steel rear bevel differential gear set is produced by GPM for use on TAMIYA CC01 scale chassis and is supplied under model number SCC1200R. The set contains replacement bevel gears intended for the rear differential assembly of CC01 vehicles, specified as steel to address wear resistance where stock brass or plastic gears are replaced.

The components are intended as RC-scale spare parts for drivetrain repair and setup. When replacing bevel gears in a CC01 rear differential, confirm gear mesh, clearances, and lubrication appropriate for steel-on-steel contact; improper mesh or insufficient lubrication can accelerate wear. Use the original diff housing and retain factory bearings and shims unless an alternative is specified by your maintenance practice.

In tuning terms, replacing rear bevel gears with steel units is a service and durability option rather than a performance tune by itself. Steel gears change the service interval expectations and can reduce gear deformation under load compared with softer materials, which can be relevant during sustained runs or heavier use typical of scale off-road driving.

Use this GPM SCC1200R set when replacing worn rear bevel gears on a CC01 chassis, and follow standard differential rebuild practices for mesh, lubrication, and bearing condition checks.