Tamiya CC-02 Chassis Aluminum Front Knuckle Arms by JAZRIDER JR-CC200-LB  [JR-CC200-LB]

Aluminum Front Knuckle Arms for Tamiya CC-02

These aluminum front knuckle arms are an RC-scale steering upgrade intended for the Tamiya CC-02 chassis, finished in anodized blue to resist surface wear and provide consistent contact points for wheel mounting. The part replaces stock plastic knuckles to reduce play under load and to keep steering geometry stable during tuning sessions and rough-surface practice runs.

Fitment follows the CC-02 layout, using the same pivot and ball-stud locations as the original knuckles so that existing steering linkages and wheel hexes remain compatible. The component is intended for hobby-grade remote-controlled models and should be handled and installed using appropriate RC tools for small fasteners and alignment checks.

Installation notes: remove the front hub assembly, transfer any bearings or wheel hexes from the stock knuckles, fit the aluminum knuckles into the steering knuckle posts, and reassemble while checking steering throw and toe settings. After installation, verify there is no binding through the suspension travel and confirm servo centring before a test run.