Tamiya CC-02 Chassis Aluminum Front/Rear Shock Tower by JAZRIDER JR-CC203-S  [JR-CC203-S]

Aluminum shock tower for CC-02

This aluminum front and rear shock tower is specified as a replacement/upgraded part for the Tamiya CC-02 chassis and is presented as an RC-scale accessory only.

Constructed from machined aluminium, the towers provide a rigid mounting point for the shock absorbers and tie into the vehicle's suspension geometry without altering the chassis layout. The part is intended for hobby use on 1/10 scale CC-02 based models where users seek a metal alternative to the stock plastic towers.

Installation follows standard CC-02 tower mounting locations; the component replaces the stock tower and uses the chassis' existing mounting pattern. Fitment checks and basic setup steps — align tower, secure with appropriate screws, verify shock eyelet mounting — are typical. Use common workshop practices such as thread locker on metal-to-metal fasteners where preferred.

Tuning note: switching to aluminium towers increases tower stiffness, which typically reduces flex at the shock mounts and shifts suspension response; drivers may need to revisit shock length, spring rate, or shock position on the tower to restore intended handling.