TAMIYA CC-02 Chassis Aluminum Rear Cross Brace by JAZRIDER JR-CC202-LB  [JR-CC202-LB]

Rear Cross Brace for CC-02

This aluminum rear cross brace is designed for the Tamiya CC-02 scale chassis and serves as a direct replacement or upgrade to the stock rear brace to reduce chassis flex. Machined from anodized aluminum in blue finish, the part focuses on rear-end stiffness to influence handling balance without altering suspension geometry.

Installation is straightforward on CC-02 layouts that use the standard rear mounting points; the brace mounts to existing attachment locations and works with the vehicle's original brackets. When fitting, verify alignment and even fastener tension to avoid preload or misalignment across the rear section.

On the trail and crawler setup, adding a rear cross brace like this one helps reduce rear chassis torsion, which can provide crisper throttle response and fewer steering corrections at low speed. It is intended as an RC-scale tuning component to adjust chassis rigidity rather than a replacement for suspension tuning.

• Compatibility: Designed for Tamiya CC-02 chassis layouts.
• Role: Rear chassis stiffening to affect handling balance in crawling and trail runs.
• Maintenance tip: Check mounting points after initial runs and re-tighten as needed.