Tamiya CC02 MERCEDES-BENZ G500 Harden Steel Front CVD & Rear Drive Shaft 16pcs kit by GPM CC2237S+12.5  [CC2237S+12.5]

Upgrade parts for Tamiya CC02 G500

This is an RC-scale driveline upgrade designed for the Tamiya CC02 MERCEDES-BENZ G500 chassis, supplying hardened steel front CVD joints, rear drive shafts, and wider hex adapters to extend track width by 12.5mm. The set targets chassis stability and more predictable on-track response when you need a modest track-width increase without altering suspension geometry.

The kit combines hardened steel #45 components where load and wear matter, aluminum wider hex adapters for wheel seating, and stainless steel pins and E-clips for secure retention. The parts are intended to replace stock stub axles and drive pieces on CC02-era models to achieve a wider stance and reduced lateral roll tendency at speed.

Installation notes: verify orientation of CVDs and drive shafts before reassembling, confirm E-clips and 2x10 pins are fully seated, and check wheel fit on the 12.5mm wider hex adapters. No special tools are included; use workshop-standard drivers and inspect for smooth rotation after fitment. Do not use these parts on full-scale vehicles, they are for 1:10/1:12 RC use only.

Use this GPM kit when you want a reliable, low-risk method to widen the wheel track on a Tamiya CC02 MERCEDES-BENZ G500 for improved lateral stability. The parts are focused on durability and straightforward replacement of the corresponding stock items to refine handling without major chassis modification.