Tamiya DF-02 Alloy Front Knuckle Arm by GPM DF2021  [DF2021]

Alloy front knuckle arm for DF-02

This alloy front knuckle arm is an RC-scale replacement part produced by GPM for use on Tamiya DF-02 chassis, intended to serve as a direct-fit steering component. The part focuses on structural durability in steering linkages while keeping weight appropriate for scale handling.

The arm is intended to interface with standard DF-02 steering assemblies and ball ends, and it functions as a mounting point for the servo linkage and steering pins. When replacing the stock plastic arm, check steering travel and toe settings after installation to confirm alignment.

Installation notes: remove the wheel and hub as required on the DF-02, transfer any bearings or pins from the original arm if needed, and secure with the original hardware torque values. Verify free movement through the suspension travel to avoid binding with the brake or drive components.

Use this alloy front knuckle arm to replace worn plastic pieces or to gain a more rigid mounting point for steering and front suspension adjustments on DF-02 setups, paying attention to alignment and linkage geometry during tuning.