Tamiya DT02/DT03/TT02B Alloy Steel #45 Rear CVD Drive Shaft by GPM DT3264SC  [DT3264SC]

Rear CVD drive shaft for Tamiya

This rear constant velocity drive shaft is an RC-scale replacement part produced for Tamiya DT02, DT03 and TT02B platforms. It uses alloy steel #45 for the driven half-shafts and is supplied as 1 pr to serve as a direct rear drivetrain replacement when stock parts show wear.

Fitment is focused on the listed chassis; note this item NOT fit for Tamiya 58374. The part is intended for hobby use only, to restore drivetrain geometry, reduce play at the rear diff output, and provide a straightforward upgrade path when replacing worn plastic or lower-grade metal drives.

Installation is typical for rear CVD swaps: remove the rear hubs and driveline components to access the shaft ends, verify set-screw and hex seating, and check axle alignment under suspension droop to avoid binding. Minor trimming of set-screws or light thread-lock on steel-to-steel fasteners may be used as needed during reassembly.

Keep replacement shafts matched to the chassis code to ensure correct spline count and length, and inspect related bearings and hub hardware while performing the swap.