This is an RC-scale front upright designed as a direct replacement or hop-up for the Tamiya DT-03 chassis. The part is aluminum and intended for hobby use only, serving as a durable alternative to plastic uprights where increased rigidity and consistent steering geometry are desired.
Installation follows standard DT-03 suspension procedures and requires basic RC tools such as a hex driver and appropriate screws; no special adapters are required when used with DT-03 mounting points. Check existing ball studs and bearings for wear during replacement to maintain smooth steering operation.
In tuning terms, an aluminum front upright is used to reduce flex at the front end, helping to stabilise steering response and maintain toe and camber settings under load. It is suitable for drivers seeking predictable handling changes on touring car setups without altering major suspension geometry.
Copyright © 2008-2026 rcjaz.com All rights reserved
