Tamiya DT-03 Aluminum Rear Hub Carrier by JAZRIDER JR-DT307-LB  [JR-DT307-LB]

Rear hub carrier for DT-03

This aluminum rear hub carrier is an RC-scale replacement part designed for the Tamiya DT-03 chassis. Machined from aluminum and finished in light blue anodizing, it provides a direct-fit option intended to replace the standard rear hub carrier on DT-03 rear assemblies.

Functionally the part acts as a mounting point for the rear wheel hubs and affects wheel alignment and suspension geometry. Swapping the original component for an aluminum carrier can increase rigidity at the rear mounting point and reduce deformation under load, which helps when making fine adjustments to toe and camber during setup and track tuning.

Installation is straightforward for model technicians familiar with DT-03 maintenance: remove the rear wheel and hub assembly, detach the existing hub carrier, and fit the JAZRIDER unit using the same mounting points and hardware. After installation, verify wheel alignment and clearances before running the model.

Note: this is a scale RC part intended only for Tamiya DT-03 chassis use, check fitment on your model before final installation and ensure compatibility with your wheel hex and axle setup.