This aluminum rear hub carrier is an RC-scale replacement designed specifically for the Tamiya DT-03 chassis. It replaces the stock rear hub carrier to provide a machined aluminum mounting point for the rear wheel hub, keeping the installation and geometry familiar to DT-03 layouts while offering the dimensional stability of metal construction.
Installation is straightforward for anyone familiar with DT-03 maintenance: remove the original hub carrier, transfer any bearings or small hardware as required, install the JAZRIDER unit using the existing mounting points and hardware, and verify wheel alignment and suspension travel. Basic tools such as a hex driver and wrench for the axle nut are typically all that’s needed.
In tuning terms the part serves as a rigid mounting base for rear suspension and steering linkages, helping maintain alignment under load and offering a consistent pivot surface for setup changes. The orange anodized finish aids visual identification during rebuilds and routine checks, while standard fastener patterns keep compatibility with DT-03 replacement workflows.
Copyright © 2008-2026 rcjaz.com All rights reserved
