This JAZRIDER JR-DT307-RD aluminum rear hub carrier is an RC-scale replacement part designed for use with the Tamiya DT-03 chassis. The unit is offered in red and uses an aluminum construction to provide greater rigidity than common stock plastic carriers.
Intended role and tuning notes: fitment at the rear hub location makes this part a direct candidate when replacing factory plastic components to reduce flex under load and to support more consistent suspension behaviour. In tuning setups it is used where a firmer rear end feedback is preferred to help with predictable handling changes during trim and shock adjustments.
Installation guidance: remove the rear wheel and original hub carrier following the chassis service steps, transfer any bearings or pins from the stock part, then install the aluminum carrier using the original fasteners and recommended driver tools. Verify wheel alignment and suspension travel after installation and check fastener torque during initial runs.
Notes on compatibility and scope: the product name specifies DT-03 compatibility; do not assume fitment on other Tamiya platforms without verification. This item is an RC accessory and is not intended for full-size vehicle use.
Copyright © 2008-2026 rcjaz.com All rights reserved
