TAMIYA DT-04 RC FIGHTER NXGEN Front C-Hubs 7075-T6 by GPM DT4019  [DT4019]

Front C-Hubs for DT-04

This upgrade replaces the stock front C-hubs on the TAMIYA DT-04 RC FIGHTER NXGEN platform with machined 7075-T6 alloy components, intended for 1/10-scale RC use. The part focuses on steering geometry stability and repeatable setup when adjusting camber and toe during tuning sessions.

Hardware from the package (screws and collars) is supplied pre-assembled to the hubs, which shortens installation time. GPM recommends using a medium-strength thread locker on suspension fasteners after test-fitting to prevent loosening under vibration without making future servicing difficult.

The hubs are anodized and offered in multiple colors to match different builds, and they replace the factory plastic/aluminum front C-hubs without modifying the DT-04 steering knuckles or upright interface dimensions.

Use these hubs when you need a firmer steering feel and consistent alignment during setup; verify fitment on your DT-04 before final assembly and apply thread locker as recommended.