Tamiya FF-03 Front Upper Linkage Mount by 3Racing FF03-06/LB  [FF03-06/LB]

Front upper linkage mount for FF-03

This is an RC-scale front upper linkage mount designed for the Tamiya FF-03 chassis and supplied as the 3Racing FF03-06/LB part. It serves as the mounting point for the front upper link that locates the front suspension geometry, helping to maintain consistent arm position during setup and running.

Fitment and role: the component is intended specifically for FF-03 layout vehicles where the front upper link interfaces with the bulkhead and suspension arms, and it plays a direct role in controlling camber and caster changes under load. Use it when replacing worn mounts or when restoring original suspension geometry after upgrades.

Installation notes: verify alignment before final tightening, use the appropriate hex screw sizes for the chassis, and check link pivot clearance after installation. If you change link length or pivot spacing during tuning, inspect the mount for interference with the suspension travel and steering linkages.

Tuning guidance: small changes to upper link position affect front roll centre and transient response, so make incremental adjustments and test on the same surface to isolate effects. Keep fasteners secure and check mounting points periodically during running sessions.