Tamiya GF01 38mm Steel Front/Rear CVD Shaft by GPM GF1238SADT  [GF1238SADT]

Tamiya GF01 38mm CVD shaft overview

This aftermarket pair of front/rear CVD shafts is produced by GPM for the Tamiya GF01 platform, offered as a direct replacement or upgrade for standard plastic or softer-metal drive components. The shafts are made from #45 steel and measure 38mm, and the set includes 12x6mm hex adapters to interface with standard GF01 wheel hex mounts.

Functionally these shafts maintain the same fitment points as stock GF01 CVDs while providing increased durability and torsional stiffness relative to softer materials. They are intended for hobby-scale 1/10 touring or off-road models using the GF01 chassis where the stock driveshaft length and hex adapter size match the listed dimensions.

Installation notes: confirm your vehicle uses GF01 standard CVD length and 12x6mm wheel hex interface before fitting, inspect pin retention and bearings during reassembly, and run a brief test at low speed after installation to verify free rotation and no binding.

For GF01 builders and maintainers who want a straightforward steel replacement with 12x6mm hex compatibility, this GPM shaft set offers a direct-fit option without altering drivetrain geometry; verify fit on your specific GF01 variant before committing to heavy use.