TAMIYA GF01 Aluminium High-Torque 24T Servo Saver with Steel Tie Rod by GPM GF024STM  [GF024STM]

Aluminium Hi-Torque 24T Servo Saver

This is an RC-scale aluminium high-torque servo saver designed for the TAMIYA GF01 (GF-01) chassis, supplied by GPM as GF024STM. The unit combines a machined aluminium body with a steel tie rod to reduce flex under load while keeping the servo protected from sudden impacts during piste or practice runs.

Functionally it acts as a mechanical buffer between the servo output and steering linkage, preserving precise control while allowing controlled slip under overload. The 24T designation corresponds to the saver interface and is intended for setups that use 24-tooth servo output engagement methods common on GF-01 compatible servos.

Installation notes: align the saver on the servo output spline and the tie rod to the steering arm without binding, verify full travel at the radio before running, and fine-tune saver engagement to balance protection and steering feel. Routine checks of fasteners and the tie rod are recommended to maintain consistent steering behaviour in RC use.