TAMIYA GF01 Servo Saver 24T with Aluminium Tie Rod by GPM GF024TM  [GF024TM]

Aluminium Servo Saver for GF01

This aftermarket servo saver and tie rod assembly is a low-cost RC-scale replacement crafted for the TAMIYA GF01 chassis. The unit uses aluminium components and a 24T gear interface to provide a firmer connection between the servo output and steering linkage while protecting the servo from sudden shocks during on-track impacts or rough-surface runs.

Installation focuses on direct replacement of the stock servo saver and tie rod at the GF01 steering knuckle and servo horn. The assembly is intended to mate with the vehicle's existing linkage hardware, so check thread sizes and mounting orientation before fitting. Basic trimming or adjustment of the tie rod length may be necessary to restore toe-in and steering neutral.

In tuning terms this part shifts the balance toward a more rigid steering feel and faster input transmission, which can help with precise corner entry and consistent steering feedback during setup changes. When adjusting, verify servo centring and steering travel after installation to avoid binding.