Tamiya GF01/TL01 38mm Hard Steel Front/Rear CVD Shaft by GPM GF1238C  [GF1238C]

Upgrade CVD shafts for GF01/TL01

This aftermarket CVD shaft set is specified for scale RC use on Tamiya GF01-based platforms and TL01 conversions. The pair is intended to serve as direct-fit front and rear driveshafts where the chassis layout accepts 38mm lengths, allowing replacement of worn hollow or plastic driveline parts with a metal alternative.

The components combine aluminium mounting features with hard steel driving surfaces as indicated by the product name, and are aimed at improving mechanical durability in the driveline path rather than changing geometry or ride behaviour. Fitment requires basic disassembly of the hub carriers and half-shaft retention hardware common to GF01/TL01 service.

Installation notes: verify overall stroke and outboard cup clearance before final assembly, inspect existing hexes and pins for wear, and confirm the set matches the 38mm centre-to-centre requirement for your axle layout. Use recommended thread lockers on mating fasteners where the original design calls for it, and recheck binding through full suspension travel.

Choose this set when metal front and rear CVD shafts are preferred for routine maintenance or when replacing aged plastic half-shafts, keeping the vehicle within the intended 1/10 scale drivetrain configuration.