Tamiya GT-01 GT01 Titanium Camber Adjustable King Pin Ball Stud by 3Racing GT-11  [GT-11]

Titanium camber ball stud for GT-01

This GT-11 ball stud from 3Racing is a direct-fit RC-scale hop-up produced for Tamiya GT-01 models, replacing the stock king pin ball stud with a titanium, camber-adjustable unit designed for suspension tuning. The part is intended for model-level suspension setup and fine adjustment of front camber angles.

Use this component where reduced flex and repeatable geometry matter in turn-in and mid-corner behaviour. The adjustable ball stud lets you change static camber and experiment with roll centre settings without replacing bulkhead components, helping you dial in predictable steering response on paved track layouts.

Installation note: this is a replacement king pin ball stud sized for the GT-01 steering knuckle and king pin assembly, intended to be installed with the original hardware torque and recommended thread-lock practices for small-scale RC components. Check fit and thread engagement before full use and test changes incrementally when tuning camber.