This pair of clamp-type aluminum wheel hubs is presented for Tamiya CW-01 wheel mounting, offered as two pcs for common vintage 1/10 buggy bodies such as Hornet, Grasshopper, Frog, Lunch Box and Monster Beetle. The hubs use an aluminum clamp style intended to provide a stable interface between wheel and axle stub while keeping a compact footprint suitable for stock CW-01 setups.
Compatibility is limited to the models listed above that share the CW-01 wheel mounting pattern; confirm your wheel hex and axle stub dimensions before fitting. These hubs are a direct replacement style intended to match existing wheel hardware and mounting location rather than alter suspension geometry.
Installation notes: remove the stock hub and inspect axle threads and wheel hex for wear, slide the aluminum clamp hub onto the axle or hex seat, align the clamp so the wheel sits flush, and secure following the vehicle's original fastening method. Use thread engagement and torque appropriate for small RC fasteners, and verify there is no binding in the wheel or excessive runout after installation.
Tuning and setup: clamp-type aluminum hubs can improve repeatability when remounting wheels and reduce deformation under load compared with thin pressed hubs. Check wheel balance and runout after installation, and make incremental adjustments if you change tyre or wheel combinations. These parts are intended for scale RC use on CW-01 based models and do not change steering or suspension geometry by themselves.
Copyright © 2008-2026 rcjaz.com All rights reserved
