This is an RC-scale rear drive shaft and wheel axle set supplied by JAZRIDER for TAMIYA Hotshot chassis variants. The component set is intended to restore rear drivetrain function after wear or damage and to provide a straightforward swap when tuning rear-end geometry on classic Hotshot layouts.
Installation is typically done at the rear gearbox and wheel hub junctions, using existing mounting points on the Hotshot series chassis. Expect a basic removal of the rear hub assembly and axle carrier to access the drive shaft, followed by reassembly with existing fasteners. No additional custom fabrication is required when used with the listed Hotshot family models.
Tuning notes: this set is a direct replacement style part, useful when restoring axle alignment or when adjusting axle endplay during setup changes. Check axle engagement and hub clearance after installation and verify that the motor, spur gear and pinion mesh remain within the chassis tolerances for the model in use.
Copyright © 2008-2026 rcjaz.com All rights reserved
