TAMIYA Hotshot Super Hotshot Aluminum Rear Lower Suspension Arms by JAZRIDER JR-THS07-LB  [JR-THS07-LB]

Rear lower suspension arms for Hotshot

This aluminum rear lower suspension arm set is a direct aftermarket option for Tamiya Hotshot and Super Hotshot 1/10 scale buggies, supplied under the JAZRIDER JR-THS07-LB designation. It is intended as a durable replacement for the factory plastic lower rear arms to provide a stiffer mounting point for the rear suspension and to reduce wear under regular running conditions.

Fit and installation notes: the arms are designed to match the stock mounting locations on Hotshot and Super Hotshot chassis, so check the fit against your existing rear hub and mount points before final assembly. Use the vehicle's original pins or screws and retain any original spacers where applicable. Minor trimming or adjustment of adjacent components is occasionally required on restored or heavily modified chassis; inspect clearances with the rear tyre and shock travel during initial fitment.

Tuning role and behavior: swapping to aluminum rear lower arms increases structural rigidity at the rear lower link, which can influence rear-end response during cornering and when landing jumps. Expect a firmer rear feel compared with stock plastic arms; use this change in combination with spring and damper adjustments to dial handling to your setup preference rather than treating it as a standalone cure.

For hobbyists maintaining or upgrading Hotshot series buggies, these JAZRIDER aluminum rear lower arms offer a straightforward way to increase rear-end durability and change suspension stiffness, but they work best when integrated into an overall suspension tune.