TAMIYA Hotshot Super Hotshot Rear Lower Suspension Arms Aluminum by JAZRIDER JR-THS07-BK  [JR-THS07-BK]

Rear lower suspension arms for Hotshot

These aluminum rear lower suspension arms are a replacement hop-up for Tamiya Hotshot and Super Hotshot scale buggy chassis. Machined and finished in black, the arms serve as a direct-fit option to replace the stock rear lower arms and are intended to increase rigidity and deliver more consistent suspension response during setup changes and track use.

Fit and function are focused on chassis-level tuning: swapping to an aluminum lower arm reduces flex at the mounting points compared with softer materials, which helps maintain shock and geometry settings under load. The part is intended for hobby-scale RC use only and fits the rear lower mounting positions of Hotshot-series Tamiya chassis without altering suspension geometry when installed correctly.

Installation notes: remove the original rear lower arms from the rear hinge pin and mounting posts, fit the JAZRIDER aluminum arm into the same mounting locations, and secure using the existing hardware. Verify hinge-pin alignment and suspension travel after installation before running the model. No additional chassis modifications are required for standard Hotshot and Super Hotshot setups.

Use these arms where increased rear-end rigidity and repeatable suspension behavior are desired during tuning sessions or competitive club racing for the Hotshot platform.