Tamiya Hotshot/Bigwig/Boomerang Aluminum Front Upright by JAZRIDER JR-THS01-BK  [JR-THS01-BK]

Front upright for Tamiya Hotshot/Bigwig/Boomerang

This is an RC-scale aluminum front upright designed for use on Tamiya Hotshot, Bigwig, and Boomerang chassis, supplied in black with a 5mm long ball connector included. The part replaces the stock front upright to offer a metal alternative that interfaces with the vehicle's front steering and suspension linkages.

Use this upright where higher rigidity at the steering knuckle is desired for chassis setup or to explore handling changes. The included 5mm long ball connector is intended to match linkage geometry that uses a 5mm ball end, so verify ball spacing and mounting points against the vehicle before fitting.

Installation notes: the upright mounts in the front hub assembly and connects to the steering linkage via the long ball connector, so basic hobby tools and attention to alignment are adequate. After fitting, check steering throw and suspension droop to ensure no binding occurs. This description refers only to RC-scale model use.

Compatibility

• Hotshot
• Bigwig
• Boomerang