This is an RC-scale stabilizer stay designed for TAMIYA Hotshot and Hotshot II/2 chassis, supplied as a pair of 2 pcs in a gun metal finish. Made from aluminum, the stays serve as a direct replacement or upgrade to the stock component to influence chassis roll characteristics and tuning response.
Fit and installation are straightforward on compatible Hotshot mount points, using the vehicle's existing hardware and mounting locations. The part is intended to provide a firmer mounting surface compared with typical plastic stays, offering more consistent behaviour during suspension travel and cornering. Check alignment and fastener tightness after fitment, and verify clearance with adjacent suspension and linkages.
Tuning notes: swapping to aluminum stays will alter front/rear roll balance depending on which stays are changed, so make incremental adjustments and test drive between changes. This component is for RC chassis tuning and maintenance only, not for full-size vehicles.
Copyright © 2008-2026 rcjaz.com All rights reserved
