Tamiya M03/M03L/M04M/M06 Aluminium Rear Hub Carrier 2 Degree by 3Racing M04M-03/2/LB  [M04M-03/2/LB]

Rear hub carrier for Tamiya M03 series

This aluminium rear hub carrier from 3Racing is made for Tamiya M03, M03L, M04M and M06 PRO chassis and provides a 2 degree option for rear geometry adjustments. The part replaces the stock hub carrier on the listed chassis and uses the same mounting interfaces to integrate with the rear suspension assembly without changing other suspension components.

Material and finish focus on durability and repeatable fit. The light blue anodised aluminium offers greater stiffness compared with typical plastic carriers while maintaining the original attachment points for straightforward replacement. The 2 degree orientation is intended as a tuning piece to alter rear geometry in small increments.

Installation notes: confirm compatibility with your chassis variant, remove the original rear hub carrier and reinstall using the vehicle's existing hardware where applicable, verify clearances with the rear upright and wheel hex before final tightening, and re-check wheel alignment after installation.

Compatibility

• Tamiya M03
• Tamiya M03L
• Tamiya M04M
• Tamiya M06 PRO